Remake of Face Shield V5 - Covid 19

cults3d

This is a remake of Benoit Le Chausseurs Face Shield V5 https://cults3d.com/en/3d-model/home/face-shield-v5-covid-19 Edit 03-31-2020: made the centre part (the infill of the cap if you will) 1mm to find the middle ground between print speed and safety Changes: - changed the location of the skewers so that the holes can be punched with a regular perforator - changed the location of the skewers so that the plasic sheet moves inward to the face for a better coverage - changed the holes for the elastic ribbon so that the 1 cm wide ribbon lays flat on the head - added Charles O'Donnells elastic straps so that the user can change the size of the screen and so you don't have to make knots (not very clean) https://www.thingiverse.com/thing:2982589/files What to use: Laminating an empty laminate pouch worked best for me because that is a tiny bit more flexible than for example a clear presenation sheet. But you can use both. A4 is attached landscape but for extra coverage of the neck, you can use A3 upright. How to use: Fold an a4 paper landscapewise in half. Draw a line 6.25cm from the centre fold and do the same thing on the other side. These lines are the guide lines for your perforator (some call this a hole puncher). Attach the outer holes first and then gently pull the centre of the sheet down. If the presentation sheet is very thick the inner two skewers can make a little mark on the plastic but it still works just fine. It is made for a 1cm wide elastic ribbon but I guess you could use other elastics as well. Also: I added insulation tape for comfort but that could make it less cleanable. Also 2: for y'all SketchUp lovers (me not included I hate SketchUp) the .skp is included so you can change at will Also 3: The bird in the picture is not included.