Reinforced and Easier to Print Rotating Face Shield - US Version

prusaprinters

<p>Thanks to Cavy for the original remix. It is exactly what I've been looking for. I work 12 hour shifts with a face shield and it's much easier to flip it up to get a drink than to take it off, set it down, and possibly forget it.</p> <p>This version reinforces the area around the pivot hole and increases the size of the pivot hole slightly. I had difficulty printing the original because the end prints as an island at the beginning and it would often come loose during printing. I also had trouble getting the hole to snap onto the pivot pin without breaking the end of the visor. This remix solved both problems with me.</p> <p>Included are the original headband piece, the reinforced visor holder, and a resized buckle that snaps over the headband mount so 3/4" elastic can be used as a headband if you don't have the type with holes in it.</p> <h3>Print instructions</h3><p>Supports are needed under the pivot pins. Use support enforcers under the pins to make life easier.</p>