Reinforced and altered Quick fit X Carriage for Igus pillow block bearings

thingiverse

This Quick Fit X carriage by Yurykk has been in use for a few months, but it has certain issues in my setup. The belt clamp positions are too close to the motor's back by 5mm, there's insufficient clearance without modification for a budaschnozzle 1.2 equipped extruder, and the carriage has some flex. To rectify these problems, I designed a modified version that requires heat set inserts for rear bearing mounts and fan/accessory mount under the platform. The mass is slightly more than the original, and it's a 4-bearing carriage with spaced out rear bearings. An experimental print will be conducted soon, along with a mirrored STL due to incorrect latch conversion. Printing instructions include inserting M3 heat set inserts at specific points and using the same 605 bearing and hardware as Yurykk's variant. Photos will be uploaded later.