Regice Figure

thingiverse

I created this Pokémon Regice figure when I was feeling bored. It has two different bases - one is more like a Super Smash Bros. trophy stand, while the other is an ice base. To print it successfully, use raft supports because this model is extremely small and needs scaling up. Be sure to keep the same scale factor. You should also know that the spiky back parts and/or arms may not lie flat on the bed, so print them with a raft too. The base and body don't need raft supports. After printing, be careful when removing the arms if you used a raft because their fingers might snap off easily. I strongly advise using glue to hold everything together once it's done. Additionally, get a rough file to clean out the holes in the body that will be filled with supports. Finally, sand down the arms, legs, and back parts if needed for them to fit properly.