Reggie The Robot - Print-In-Place

prusaprinters

Meet Reggie The Robot! - The loveable, print in place, fully jointed robot toy! Easy to print, has been tested down to 60% scale but your printer has to be really dialed in for success. 80% Scale Takes Roughly - 1h:22m 100% Scale Takes Roughly - 2h:15m Bear in mind 100% scale is still small! - 73mm from head to toe, so you may want to scale up to 200/300% at a 0.3 layer height, for a really robust Reggie. I really hope you enjoy this design! It's taken a fair few iterations to get a reliable, robust print and I'm really happy with the end results. Any questions, please comment and I'll reply asap :D Have Fun! Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No Supports: No Resolution: 0.2 Infill: 20% Filament: Various PLA+ Multiple Notes: A good first layer is essential. Make sure there are clear gaps around the joints, otherwise breaking them free can be tricky. If you struggle with this, raise your Z offset by 0.05mm And test again. Post-Printing ============= Green = 60% Scale Red/Yellow = 80% Scale - White = 100% Scale - Pink 200% Scale 80% Scale Category: Model Robots