
Reduplicator with 10x15 drag chains
thingiverse
The original cable chains for the Wanhao I3 are extremely small and nearly impossible to pull the servo leads through without disassembling the connector. I switched to a 10x15 cable chain with small doors on each link, making it incredibly easy to route cables. If you plan to use the 10x15 cable chains, you can use a sharp flush cutter to remove the top or bottom of the Wanhao cable chain links. This allows the cables to be removed, being extremely careful not to cut any wires. I also added a cable chain to the Y-Axis. The mount to the carriage plate is specifically designed for a certain carriage plate and may not work with yours. The photo showing the ReDup-Y-Axis-DragChain-10x15.stl attached to the Y Carriage plate is an older version, the current one is slightly longer to avoid contact with the heated build plate. The X Axis drag chain uses 21 Links, with the last two connected to the rear bearing plate flipped. The Z Axis drag chain consists of 19 Links. The Y Axis drag chain has 18 links, with the last two connecting to the y axis frame flipped. The 10x15 link that connects to "DragChain-Male-10x15.stl" may require a small tab to be cut to allow the male connector to rotate. This small tab matches up with the two small notches on the male connector. DragChain-L-Mount.stl replaces the "X Gantry Cable Box Bottom.stl". Lower-Mount-DragChain-10x15.stl attaches to the side of the tower to connect the Z Axis chain. DragChain-Male-10x15.stl and DragChain-Female-10x15.stl are also required. Redup-Y-Axis-Mount-DragChain-10x15.stl goes on the back of the Y Axis frame to attach the Y Axis Drag Chain. ReDup-Y-Axis-DragChain-10x15.stl attaches to the Y Carriage plate to provide a place to connect the Y Axis Drag Chain. The Y Carriage plate is available at https://www.ebay.com/itm/Carriage-Plate-V3-Prusa-i3-Wanhao-Duplicator-and-Monoprice-140mm-Y-Rod-Distance-/323171898907. One meter of 10x15 Cable chain can be purchased at https://www.amazon.com/gp/product/B07K59D3DH, with one meter being just enough for all three axis. I had to order two.
With this file you will be able to print Reduplicator with 10x15 drag chains with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Reduplicator with 10x15 drag chains.