Redcat Gen 8 V2 Relocated ESC/Receiver Mount

thingiverse

This is version 2A and 2B of three different designs for alternative ESC/Receiver mounts for the Redcat Gen 8 International Harvester Scout II scale crawler. When using narrower aftermarket bodies, you'll need to relocate the receiver and ESC since the original side guards (including the ESC/receiver mounts) will be removed. Additional hardware needed: Version 2A- 2pcs: M3x16mm button head screws Version 2B- 4pcs: M3x10mm flat head screws 2pcs: M3x16mm button head screws Version 2A is labeled as "Gen 8 V2 ESC & Receiver Mount 1pc.STL". This design is a one-piece version and will require quite a bit of support material to print standing upright. Version 2B requires two files, "Gen 8 V2 ESC & Receiver Mount Top.STL" and "Gen 8 V2 ESC & Receiver Mount Base.STL". This design is the same but in a two-piece version so that support material will not need to be used nearly as much. The two pieces are bolted together using 4pcs of M3x10mm flat head screws. To install either of these mounts, you'll need to remove the forward two battery tray screws and use 2pcs of M3x16mm button or cap head screws in their place. The attached picture shows how the mounts are intended to be installed. Redcat parts on Thingiverse are released under the Creative Commons License Attribution-NonCommercial-ShareAlike 4.0 International (CC BY-NC-SA 4.0). We want to share these parts with the world and inspire people to make and share their own parts for their vehicles. In keeping with the non-commercial clause of this license, if you produce this part (Gen 8 V2 ESC & Receiver Mount 1pc.STL) or (Gen 8 V2 ESC & Receiver Mount Top.STL) + (Gen 8 V2 ESC & Receiver Mount Base.STL) for others, you may not receive compensation in excess of $6.00 per part, plus your shipping costs. This number is calculated based on an average estimate of material cost and machine running costs.