Redcat Gen 8 V1 Relocated ESC/Receiver Mount

thingiverse

This is version 1A and 1B of 3 different designs of alternative ESC/Receiver mounts for the Redcat Gen 8 International Harvester Scout II scale crawler. When narrower aftermarket bodies are used, you'll need to relocate the receiver and ESC since the original side guards (including the ESC/receiver mounts) will be removed. Additional hardware needed: Version 1A- 2pcs: M3x16mm button head screws Version 1B- 3pcs: M3x10mm flat head screws 4pcs: M3x16mm button head screws Version 1A is labeled as "Gen 8 V1 Receiver & ESC Mount 1pc.STL". This design is a one-piece version, and will require quite a bit of support material to print standing upright. Version 1B requires two files, "Gen 8 V1 ESC & Receiver Mount Top.STL" and "Gen 8 V1 ESC & Receiver Mount Base.STL". This design is the same as Version 1A, just in a two-piece version so that support material will not need to be used nearly as much. The two pieces are bolted together using 3pcs of M3x10mm flat head screws. To install either of these mounts, you'll need to remove the forward two battery tray screws, and use 2pcs of M3x16mm button or cap head screws in their place. A picture shows how the mounts are intended to be installed. Redcat parts on Thingiverse are released under the Creative Commons License Attribution-NonCommercial-ShareAlike 4.0 International (CC BY-NC-SA 4.0). We want to share these parts with the world, and we want to inspire people to make and share their own parts for their vehicles. In keeping with the non-commercial clause of this license, if you produce this part (Gen 8 V1 Receiver & ESC Mount 1pc.STL) or (Gen 8 V1 ESC & Receiver Mount Base.STL) + (Gen 8 V1 ESC & Receiver Mount Top.STL), you may not receive compensation in excess of $5.50 per part, plus your shipping costs. This number is calculated based on an average estimate of material cost and machine running costs.