Redcat Everest-10 Skid plate triangulated. Low COG battery tray. Upper link relocate bracket. Axle Lights

thingiverse

This combination of parts will solve your torque twist issue and Improves the 4-link geometry to match more modern machines such as the scx10. The lower COG design will help your rig climb steep grades and sidehill much easier without rolling.The skid plate offers slightly higher ground clearance and triangulates the lower links. Uses original screws to mount links and transmission. You will need 4x 3mm screws 10mm long to mount the skid to the chassis. Trans will be slightly higher and causes interference with the bottom of battery tray. You can cut the tray or use the 3d printed tray. Brim or raft recommended to stop mount points from warping during print.Upper link relocation brackets move the lower and upper links closer at the frame connection point for better link geometry. This also sorts the stock link lengths to give you improved caster and pinon angle at the differentials. The longer legs of this bracket go to the upper mount hole where the upper link was located stock. Will require 4x screws and lock nuts to mount to frame. Link bolts need to be 5mm longer than original or swap for same length with flush mount head. Sorry... Don't remember exact lengths on this set of hardware.The Low COG battery tray is designed to give you the clearance needed for the skid plate mod as well as lower the battery tray 10mm and the esc tray 20mm to lower the overall center of gravity for your rig. Tray is designed to work with small 3s cells(1500-2200mah) approx. 35mm x 75mm. Uses original battery tray mount screws. The second battery tray turns the battery sideways and lowers both esc and battery 10mm lower than the longways batt tray design.Axle mounted lights are just for fun but produce quite a bit of light for evening play. They mount off of existing screw holes on the axle using m3x10mm bolts. Each fixture uses 2 5mm led bulbs wired in series. All 2-4 fixtures can then be wired in parallel and connect to an additional channel on rx. Do not hook directly to batt because the 2 bulb config cannot handle more than 7v max. I prefer to face the rear mounted lights forward also to light up the underside of vehicle, back of front tires and out in front of vehicle.