Recurve Archery Bow Sights

youmagine

I only shared the altered sections so be sure to download the original design for the additional parts. The screws needed are approximately 160mm long for vertical and 60mm for horizontal which should suffice. The part was printed with a 26% infill and a 2mm shell, resulting in solid X beams. When printing with Cura, I reduced the bottom by 2mm, and it proved strong enough but left it thicker so you can decide for yourself. With settings of 50mm/s and 0.25mm LH, the print time was roughly four hours. I utilized a M5 threaded rod for the larger screw as I couldn't locate an M3 one that met the required length. The bottom nut is a nylock nut to keep it securely in place at the top; there's a standard nut and a wingnut adjusted to remove all slack, then tightened together for a smooth adjustment that exceeded my expectations.