Record/Vinyl/Sleeve Wall Mounts

thingiverse

Update 3/18/18: The prints for the sleeve mounts are excellent. They are now finished (single and double) and I am very pleased with their design. Unfortunately, I am not satisfied with the loose record mounts. I am experiencing issues with them slowly collapsing over time. For the time being, I am putting these on hold but plan to revisit them sometime in the future. For the sleeve - print one side of it. NOTE: this design currently fits a single-sized record sleeve. One for doubles has also been added. The back is designed for a cut in half (1" x 1") 3M mounting square. For the loose record mount - print flat with the back facing down. Use supports carefully. Be very cautious when cutting out the support or your record will not be parallel to the wall. Also uses cut-in-half mounting tape. Hence, the groove in the back. I'm going to take some better pictures during the daytime. I am open to suggestions!