Recessed Obelisk

thingiverse

I created this design specifically to be printed on a Creality CR-10 (300 x 300 x 400) in vase mode. Scaling it up should work just fine, but be aware of one critical issue: *CAUTION*. If you have a smaller format printer and need to scale it below 75%, I strongly advise against using vase mode as intersecting geometry will cause the slice to fail miserably. However, at any scale set for 0% infill with multiple perimeters, it will slice and print without issues. Every angle is 45 degrees or greater, making infill and support completely unnecessary. Enjoy your print!