Receiver Box Model with Antenna Mount and Logo Plate Blank

thingiverse

So I design this 3D printed receiver box that I call Receiver Box Model with Antenna Mount and Logo Plate Blank. For the purpose of replacing a modified receiver box that I purchased years ago before I knew about 3D printing and before it was made available in my area. This receiver box has an integrated antenna mount to address the issue with receiver boxes having short antennas that are too short in length, making the regular antenna mount on the RC vehicle itself unusable, leaving the antenna dangling around inside the RC vehicle. This 3D printed receiver box is designed to solve that problem and also includes a piece of square plastic for adding a logo on it, as shown in the photos with my YouTube logo, but the one you will receive will be blank so you can add your own designer logo as desired. I also wanted my RC vehicle to look nicer than my modified receiver box. If you wish to download this file, you'll need two screws about 3x20mm and double-sided tape, and the photo should give you an idea of how to install it, so enjoy this upgrade. But I have to inform you that depending on your 3D printer, you might need some super glue to fill in the gap between the antenna mount itself where the antenna tube goes in and the antenna tube itself for a secure fit. Also, keep in mind that you may need to use some sandpaper to get rid of rough edges so you can open and close the receiver box without too much effort. And finally, this receiver box is not waterproof, so remember that as well.