receipt paper shopping list

thingiverse

Although this is not a remix as it is a from scratch creation I did mark it as a remix because it is fully inspired by https://www.thingiverse.com/thing:2786713. This will add many improvements over the original thing, **the improvements include the following**: 1. 15x4 disc magnets, neodymium magnets work best. 2. Separate pen holder 3. More clearance in paper arm 4. A M8 nut on the arm to stop the roll from falling off. **To assemble you will need the following:** 1. Glue: must stick to your material, I used E6000 and printed in PLA. I have also used original Gorilla glue (the amber, foaming one). 2. M8 plain nut, or M8 flange nut (smooth, or non serrated flange), or M8 thumb screw. 3. 6 x 15x4 disc magnets, neodymium magnets work best. You could probably get away with 5 of them if you use only one in the pen holder. **Recommended extras:** 1. A half-page address label as a better writing surface 2. If using a plain nut or some thumb screws then I also recommend an M8 flat washer or fender washer. 3. Sandpaper [These are the magnets I am using](https://rover.ebay.com/rover/1/711-53200-19255-0/1?ff3=4&toolid=11800&pub=5575362044&campid=5338241480&mpre=https%3A%2F%2Fwww.ebay.com%2Fitm%2F302350141410)