Rear vent duct cover for Creality LD-002R

thingiverse

This rear vent cover for the Creality LD-002R SLA printer lets you attach a 3" duct hose to exhaust the fumes. To do this, you'll need a clamp if you're using a 3" hose, since the port's diameter is only 70mm - just shy of 3". If you prefer to use a 4" hose instead, you can print a 20mm tall tube with an inner diameter of 70mm and an outer diameter of 101.6mm. The cover attaches via magnet. I used magnets that were 60mm x 10mm since they're what I had on hand. The ones I bought aren't available anymore, but if the ones you get come with adhesive strips, don't use them - I didn't design it for that purpose. Connect the other end of the hose to a 120mm fan and those nasty fumes will be sucked right out of your print room!