REAR FRAME BRACE FOR LOWER ALL THREAD POLES

thingiverse

Hey Guys!\r\n\r\nI was asked to remix this part to fit our uniquely different frame design, which features a lower all-thread location than standard designs. Myself and some others are stuck with frames that require specialized upgrade parts due to this configuration. So, I remixed this one (thanks a lot @Leo_N).\r\n\r\nIn addition to modifying the brace by removing part of it restricted by the all-thread, I added attachment points to the base for secure screwing onto a table or plywood board, as well as incorporated some extra features and my personal touch.\r\n\r\nI'm leaving this project in progress until someone confirms that it works. Meanwhile, I've already got another design in mind, so I won't be pursuing this one right now.\r\n\r\nLet me know if anything else needs attention. EDIT: 3/29/2018 A new model is now available, featuring nuts that can be tightened directly to the brace for easier installation. A test fit piece has also been added, allowing you to verify compatibility without printing the entire part first. EDIT: 4/2/2018 I've created a revised model (V2) in response to concerns about linear bearings being obstructed by the top of the brace. I've lowered the bearing area by 0.25" while keeping the motor attachment height unchanged. A test fit piece is included, so you can check compatibility without printing the entire thing.