Rear cover for ATEM Mini Case

thingiverse

This is a rear cover for the Blackmagic ATEM Mini Case by calebpike. (https://www.thingiverse.com/thing:4429238) It locates with two 4mm pegs at one end and a single 4mm indexing plunger at the other. I drilled the locating holes in the case with a 5mm bit which seems to work well. I have included drill templates which can be used to line up the holes, I have added 0.5mm to the edge since the version I used as I had to remove a small amount of material at the top of the cutout on the case to make it fit, but I don't have another case to test it on to verify the fit so you may want to double check alignment before drilling. The indexing plunger I used was https://www.amazon.co.uk/gp/product/B086YSQ74C which is attached using M6 threaded inserts: https://www.amazon.co.uk/gp/product/B07LB2MMH1/. After melting the inserts in (from the outside) there may be a bit of plastic in the thread - screwing the plunger in and out form the outside a couple of times cleaned that out. It is a bit fiddly to then screw the plunger in from the inside but is doable with some needle nose pliers. It will fit with the right angled power cable and HDMI connector still in the back of the ATEM Mini. I printed with supports on and 100% infill to try and make it as durable as possible. Fusion 360 file is included if you want to make any tweaks.