ReadyNAS disk tray

thingiverse

#ReadyNAS disk tray ##Description This is a disk tray (3.5 inch hard drive) for ReadyNAS NASs from Netgear. ##Parts to print * hdd_try.stl (x1) : ~6.25 hours * hdd_try_handle.stl (x1) : ~1.2 hours * hdd_try_handle_clamp.stl (x1) : ~0.25 hours Total print time : ~7 hours ##Assembly You need : * 20mm long, 2.5mm diam (M3) screw with nut (x1) * 5mm long, 2.5mm diam (M3) screw (x2 min, x3 max) * compatible screws for your hard drive (x3 min, x6 max) 1. Remove all supports 2. Put the handle on the tray, put the nut in its hole and screw everything 3. Screw the clamp to the handle with the biggest tooth facing the hard drive 4. Screw your hard drive in place with at least 3 screws in triangle : two on top at each end and one on the middle bottom hole <br> <br> #Print settings ##Quality * 0.28mm resoution * 30% infill (tray & handle), 100% infill (clamp) * 50mm/sec print speed ##Supports * With supports (tray), without supports (handle & clamp) * No raft