Ready to use marlin 2.1.2 firmware for Geetech Prusa i3 pro with BLtouch sensor

thingiverse

Hello, This is the marlin firmware version 2.1.2 for printer Geetech Prusa i3 pro w / b it has the geetech sensor 3d touch for auto bed leveling (bilinear mode) enabled configured NOTE: cabling of the sensor as explained by geetech here: https://www.geeetech.com/blog/2016/09/how-to-use-3dtouch-auto-leveling-sensor-on-your-geeetech-prusa-i3/ NOTE: probe offset has been manually measured with caliper and are for the 3d printed support that is on the previous link, Z offset is 3.47mm, in case you can tune with z babystep during printing and after saving it as z offset NOTE: interface is in italian, you can change in configuration file. NOTE: i still with original shitty metal clamps for glass bed at the moment, so i replaced bed size with 200x180 to avoid hittings, if you use other fixing can change. NOTE: in the 2.1.2 there are 2 features that limit vibration and GREATLY increase print surface quality, both are enabled: Input shaping and S curve acceleration