RDA Travel Case

thingiverse

This is a portable case designed specifically for RDAs. The current design depth is ideal for the Mutation 4 with its standard cap. The cap fits securely, and when your printer is properly configured, it snaps into place perfectly. However, the case's design takes it up a notch by incorporating two 6mmx3mm magnets to ensure the lid stays closed during travel (in a bag or other enclosure). The magnets used in this design can be purchased at an affordable price - under $5 for 100 of them - from this shop. Print Settings Printer: Flashforge Creator Pro Rafts: No Supports: No Resolution: .25 Infill: 15% Notes: I currently print these with three shells, but that's a personal preference. Post-Printing Cleanup and Final Touches I use an artisan brush to clean them up, followed by 1500 grit sandpaper and acetone for a smooth finish with a decent shine. The magnets can be installed using your preferred epoxy - just make sure to apply enough to the hole and the back side of the magnet to get a secure fit. Excess epoxy should be cleaned off carefully. If you notice "Elephant Feet" edges where the parts made contact with the bed, I recommend using a small file set to trim them down gradually. These files can be found at affordable prices at Harbor Freight or hobby shops - you can even use a nail file like those used for fingernails.