RCNC X Belt Version - Modified Square Tube Holders

thingiverse

This is Modified sizing for square tube holders. My printer produced them at a precise 25.4mm dimension, exactly as drawn. However, American-sized tubes measured precisely the same in some areas, yet varied slightly in others, measuring up to 1.01 inches or 25.7mm in certain spots. I inadvertently applied too much pressure while installing one, causing it to break. To rectify this issue, I adjusted their width to 25.8mm, resulting in a snug fit that required the use of a clamp to finally seat them properly. The X sides are specifically designed for the X belt version. In contrast, the Y bracket requires mirroring before printing and must be produced as two separate units.