RC305 Mount

thingiverse

I use FPV goggles without a built-in RX so I've always just zip-tied my Boscam RX to a 1/2" dowel to get it up in the air. But that was clunky and tended to fall apart. So, I took a few minutes and tossed this together in OpenSCAD, then took a few more minutes to add the ability to add custom text on the front. If there's interest, I could tweak the design so the mount is customizable as well, allowing different sized/shaped dowels to be used. This just happened to be what fit my needs. It fits my RX very snugly; it doesn't come out without a bit of a fight. You may want to tweak the sizes in the RC305 module slightly if it's too tight for your RX. I've included the OpenSCAD source, so that's easy to do. Print Settings: Printer Brand: RepRap Printer: FolgerTech 2020 Prusa i3 Rafts: No Supports: Yes Resolution: 0.24mm Infill: 10% Notes: Doesn't need much infill; the wall around the RX prints basically solid, but the bit around the dowel has some infill to it. I did print with supports so I could print it upright. The text still prints well even though it's not supported. You could edit the SCAD to drop the mount down even with the build plate and print without supports, but I liked the look of it like this, and the support was easy to deal with.