RC Yamaha Sr Viper 1/6 Modding Parts

prusaprinters

<p><strong> This is a DIY starter kit, you NEED a base model Kidztech 1/6 Yamaha and you WILL have to cut parts of it and add hobby grade electronics for this to work at all !<br/> I can help for difficult parts, just ask in the comments</strong></p> <p><strong> APRIL 2019 UPDATE :</strong> Pascal made his V1 files available on Thingiverse, this means i can now release all my modded files too !! THANK YOU PASCAL !! :D<br/> Link to his Polaris Rush page : <a href="https://www.thingiverse.com/thing:3581090">https://www.thingiverse.com/thing:3581090</a></p> <p><strong> If you need a replacement bulkhead that will fit without any mods see my original part here : <a href="https://www.thingiverse.com/thing:3265111">https://www.thingiverse.com/thing:3265111</a></strong></p> <ul> <li>The rod-end i used are Traxxas TRA1942.</li> <li>The front shocks i use are RC4WD Shocks 80mm w/ internal springs, 10mm diameter.</li> <li>All the bolts and nuts are M3, mostly M3x16 but some M3x12 and M3x20.<br/> You will also need a 3mm steel rod, long enough to cut and make axles for the front and rear upper skid mounts and a way to keep them there (set-screw collars).<br/> You could also use some long M3 all-thread rods cut to lenght and some nuts.<br/> Of course, a couple of drill bits can adapt those parts to any size rods or screws you might have laying around !</li> </ul> <p><strong>* UPDATE:</strong> With "promod_bigshock_upper_Aarm" you should be able to fit up to 15mm diameter shocks !</p> <p><strong>* UPDATE:</strong> Use "promod_bulkhead_higher_shock_mount" for longer shocks (Should help fit shocks up to 90mm or 100mm with limiters) !<br/> To fit the long track conversion, you will need to remove the factory On/Off switch from under the seat and grind the white plastic hump underneath flat, or your track will rub on it.</p> <h3>Print instructions</h3><p>Category: R/C Vehicles</p>