RC/Traxxas Stampede 4x4 Snowplow

thingiverse

I built this snowplow for my Stampede 4x4. The plow itself was too large for my printer, so if you need to print it in separate pieces, you'll need to use the left, right, and middle parts, attaching both the left and right parts to the middle part using screws. The mount is designed specifically for a Stampede bumper and attaches with three bolts that pass through the three holes in the bumper and the mount's 1/4 inch holes. Since I haven't tested it yet, my current prototype consists of only drilled holes, so there may be adjustments needed. Most of the components are held together with screws. Two screws on top were originally intended for springs to make winching easier, allowing me to pull the winch up more smoothly.