RC Transmitter Wall Hanger

thingiverse

I remixed this Pistol Grip RC Transmitter wall hanger by Rewp to be slightly larger as it didn't fit my old Futaba 3PX, and it was a tight squeeze for my Flysky FSGT5 and the Spektrum DX3 I have. So I cut off the bottom as I didn't find it was needed and it reduced print time, made it slightly wider and deeper, and it works great so far. I only used one screw for mounting and it seems fine - but i did put a hole down lower so that you could drive another through the back if you wanted, you'd just need to drill it first. I'd stand it up on end before printing and then you dont' need any supports.