RC Snow Ski - 12mm Hex

thingiverse

Designed a multi-piece Snow Ski design that uses 2 parts that are repeated in design. No need to print a left side and a right side separately. Break the ski? Reprint the bottom portion instead of a single one piece unit. The base ski has countersunk holes for self tapping M2 Socket Head Cap Screws. Nominal length for the screws is 12mm, but 10 will do; four (4) per side. There are two uprights. They are symmetrical, so you can print both in the same orientation on a bed and minimize the support cleanup. The 35mm and 45mm are the axle centerline heights from the ski bottoms. Depends on how much your front A-arms lift your chassis. Has a built in 12mm hex guide cutout with a hole for a 5mm axle shaft. Shown in the image is the 45mm uprights mounted on a 1/10th 2WD Traxxas Stampede.