RC Plane STand

myminifactory

Simple yet sturdy stance for rc models. Print settings: All components except belka.stl require the following: layer height, 0.2 mm; top/bottom layers, 3; outline/perimeter shells, 3; infill, 20%. Belka.stl demands special treatment with layer height at 0.2 mm, top/bottom layers set to 4, outline/perimeter shells increased to 4, and infill density boosted to 50%. For structural integrity, supports are necessary for pokretlom.stl and pokretlod.stl. To complete the assembly, additional materials are required: 6 M6 carriage bolts, each 30mm long; 4 M6 carriage bolts, each 20mm long; 10 M6 nuts; 2 PVC tubes with an outer diameter of 32mm (1 1/4 inch) and a length of 50cm; a thin sheet of foam rubber sourced from an old mouse pad.