RC Metal Tank MK001

pinshape

I present the MK001! This is inspirate to the iconic Tank off the Metal Slug Saga. This prints is 18 x 20 x 15 (cm) with Full details and moving tracks. I put a lot of work into this design so it requires no special tools RC Moving parts: 2 x tracks 1 x turret 1 x Cannon 2 x machine guns Please note, there are additional materials needed (such as screws nuts, washers and bearings, all listed below). ON TO THE DETAILS: SIZE: 18 x 20 x 15 (cm) PRINTER SIZE: 200mm x200mm x100mm NUMBER OF PARTS: I'm just going to say 138 ASSEMBLY GUIDE: Manual Poster Included (nice to hang too) MATERIAL LIST: Electronics: 2 continuously rotating servos 3 nano-servos Recommended battery: 2S 7.5V 500mAh Mechanics: 3 ball bearings 13x4x5mm 230 M3 x10mm screws 3 M3 15mm screws 2 M3 25mm screws 22 Nut M3 3mm 1 M3 58mm screw 1 M4 25 mm 2 M4 45mm 1 M4 10mm washer 1 M4 20mm washer 5 nut M4 1 paperclip 1 x Glue 100 x patience If you run into problems, comment or message me and I'll see what I can do to help Thanks for check this out!