RC Flying Wing Fuselage for small Printers

thingiverse

I had to divide the FuselageBack STL in two parts because my Printer can't print such high structures. Normally, I wouldn't upload this remix again, but there is a notable difference. I cut the part not all the way through that strut, so I increased the contact area and avoided weakening that strut. In my own print, I used supports for angles over 80 degrees, but ST61's idea of cutting the part into three pieces is brilliant, so I added a second set of STLs: FuselageBack2main and FuselageBack2motorholder. My slicer (Cura) had issues with the thin walls of those CG-Circles, causing holes to form. To fix this, I created an STL of two 10mm circular plates that fit into these holes. I designed this by modifying Stanton's STLs using meshmixer.