RC EDF Outrigger

thingiverse

Warning There is a high risk of total loss of the boat/craft. Test run: https://www.youtube.com/watch?v=chB-g0aLZ-g There is a high risk of water getting inside the hull. Seal/plug unused holes and seal lids carefully. Seal around cables. Angle the rudder leading edge so that the bottom corner is the most forward one. See image. Rudder dimension: Length about 42mm, height about 33mm (about 29mm in water). Servo/Rudder holder is just for testing. Will probably change shape. First test: https://www.youtube.com/watch?v=IjCiJjNobmI New front part "Front_v3". Found an error in the old one. Rear_v2: Changed the opening for "one size lid" (Lid_v2). Added a groove in the stern to test a fibre/thread reinforcement (reinforcement from the carbon tubes around the stern). Lid_v2: One size lid (for "Rear_v2"). Added "138.5mm.stl" to help glue the sponsons in place on 400mm tubes (6mm tubes). Added an "extension" if you want to try another hull length (I have not used this). Sponsons/Riggers: https://www.thingiverse.com/thing:5991760 M3 tap for M3 screws. 6mm carbon fibre tubes 400mm long. 70mm EDF. Thank you JSeds for inspiration. https://www.thingiverse.com/jseds