RC Draco Tailwheel Correction

thingiverse

This is to correct the tailwheel misalignment that many RC Draco's suffer from. I have made these in 2.5° increments left and right - hopefully there's one in there that will work for you! Measure your misalignment as in the photo above and select the closest degree in left and right. I can't for the life of me remember whether a left offset needs the positive or negative offset (and vice versa), but they are 10 minute prints, so it doesn't hurt to double up. I printed mine with 10 wall layers and 100% infill for the strongest results. This is a small piece of plastic on a large RC plane, so make it strong if you can. You may need to clean up the holes a small amount if you have any elephant foot with your printer, but the holes are 1mm for the springs and 2mm for the retainer screw. The 4mm square opening should fit snugly. Mine fit with a small amount of pressure and then just snapped into place. Thre is a LOT of play in the linkages between the rudder and tailwheel in the RC Draco, so this part fitting snugly is probably a good thing to help reduce that. I hope this part help someone enjoy RC flying!