RC Car service and display stand (1/18)

RC Car service and display stand (1/18)

thingiverse

This is a custom RC display/service stand for 1/18 cars, but could be modified for bigger. It's a remix of a lot of various contributors here (thanks to all for their work), see them linked on the left. I took the existing stand by razvan, which was modified by chad, and modified it further to make the stand a little smaller and less filament. I combined the drawer system from CaptainObvious to make a sliding drawer underneath the stand to hold all the parts for the car. I customized the size of the drawer and frame, as well as the inside of the drawer to hold the parts I need. This also allows me to just grab the drawer if I need to take the parts with me somewhere. I made 2 optional side containers, one for each side of the stand, held by small T3 or T4 screws. The right side holds the controller batteries and spare car battery, the left side holds the car's manual. These screw on and if not needed you don't have to use them. Most pieces should be printable without supports, but there are a few that need it. The side pockets need them for the tabs, and perhaps the top piece depending on how good your printer is at bridging. Any questions, leave them in the comments and I'll do my best to answer.

Download Model from thingiverse

With this file you will be able to print RC Car service and display stand (1/18) with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on RC Car service and display stand (1/18).