RC Car Flat Pushpin or Flat Cone

thingiverse

Human: Used to define and limit round trip lanes in an off-road R/C car circuit. Very easy to print - just do it as is, adding a bit of support on the center of the dish and spike to hold the top roof of the flaps in place. Note that once printed, the flaps act like springs, allowing them to be bent slightly to fit into position. See pictures for better understanding. Place them wherever you want and push down to stick them to the ground - make sure the ground isn't too hard! 100% infill for the dish 20% infill for the spike Enjoy your experience!