Rc Boat, MK2-REMIX

thingiverse

UPDATE: 24/06/2020 Added complete hull and complete hatch for people with big printers who are willing to take on the challenge! Have Fun!!! UPDATED: 17/06/2020 ADDED: Twin water pickup rudder, Print laying on its back for added strength (back edge of rudder not top) - no supports needed. ADDED: Electronics tray, Printed with motor mounting plate down. It just fits on an Ender 3. If your printer is smaller, you can cut it in half and glue it together - may need a little reinforcement though. NEEDS SUPPORTS. CURRENTLY WORKING ON: Printed Water cooling system lines for neat routing. Decided to make some changes to an already fantastic design. Thanks to Sergey for all the hard work he has put into this! This remix allows you to use the Traxxas Radio Tray/Retainer for Spartan P/N#TRA-5724R, which lets you install your motor, esc, servo, receiver before putting the whole assembly into the boat. I've also air-tight sealed the front sections of the hull. After gluing pt4 and 5 together, fill them with foam before joining to PT3. There is one resin pour advised once you have your shaft in and all of your hardware bolted on the back. I recommend putting a little anti-seize or grease on the threads then bolting it all on. Stand the boat upright and pour about a 5-6mm layer of resin on the inside of the transom. It locks all the nuts in place forever and also seals your shaft tube as well. Very easy to do, polyester resin can be bought from most hardware stores and is very cheap. ***Use Hull PT1 wholes if you plan on using the printed hardware on the back*** Thanks everyone! I hope you enjoy the boat. Feel free to ask any questions - I'll have photos and a video guide coming over the next few weeks as I start the whole print process for my friends.