Razor Crest Mark 2 Side Doors Servo Controlled

cults3d

https://www.youtube.com/watch?v=WbDxr2Zwsh4 TheDoors were made in Tinkercad. Edit it online https://www.tinkercad.com/things/6QdbEX5cF8o The Servo Tray was made in Tinkercad. Edit it online https://www.tinkercad.com/things/7temj9SIfl8 In the video I need to take the doors off and make sure they are very free in the hinge area. That is why you see slight stuttering. No real way to attach the tray. I will put it into my full size model and see if it's a friction fit or if I need a little hot glue. Hot glue may be best in case you need to remove the tray again. You will need the mini servos that are the cheap ones they sell on Amazon. Then you need to clip off the mounting tabs. Use support on the doors. Block support just above the round part of the pushrod where it enters the door bracket. Support under is ok but Cura tries to put a tiny piece of support into a small area but was easy to remove. No support on Servo Tray needed. These doors are an optional addition to the RCM2 by Fine Engineer: https://www.thingiverse.com/thing:4607202