Razor Brush Stand (No Supports)

thingiverse

This is a one-piece razor stand holder that I have made that requires no supports.To print it correctly, just rotate it 90 degrees and have it laying down with the tall rod directly on the baseplate/bed. Took me around 2 hours to print so it's relatively quick..Short version has a 3.5in. clearance underneath the top razor holder, tall version has a 4.5in. clearance underneath. Print accordingly to the length of your razor. You can hold on to the middle part of the bottom base when taking out or putting in your razor/brush to stop movement.The design was made without much flat surfaces to prevent still water from sitting on it and causing any water damage / marks.