Razer Naga Pro Dock charging station with USB

thingiverse

SCALE DOWN TO 10% (I forgot to do it before upload).This is a dock for the wireless Razer Naga Pro Mouse. Working USB 2.0.Assembly is pretty obvious but I will try to upload a video or something..Polarity is important for charging the mouse . I uploaded a photo of original thanks to reddit user lordwumpus.What you need:1 Old euro charger to salvage the 2 prongs/pins (cut them deep and adjust the height you need afterwards.)1 spring from a pen, preferably softer (cut in half)Hot glue gun 1 Old USB 2.0 cable (4 wires - red, white, green, black)1 Usb 2.0 female connector2 Thin wires red and black (around 5cm will be plenty)1 or 2 small magnets (neodymium will be best, and you can adjust the holes to make them fit your magnets)Soldering Iron, solder and fluxHeatshrink tubes or electrical tapeA drill for a hole in the base I forgot to design in xDAssembly:1 Print all parts2 solder the 2 thin wires to the pins from the salvaged electric plug3 assemble razer1 and razer2 parts like in the picture I uploaded (the notch on razer2 goes on the bottom it is meant for the female usb to sit in.)4 install the springs on under the pins and fish the wires through the springs in razer1 part from the bottom and secure them inside( i used the hot glue and then made a small hole in the glue) Check the polarity picture to make sure red and black are in the correct place!!!5 Now you have working spring loaded pins for charging that are secured. Now glue the female USB port in the notched part.6 In the base part drill a hole for the cable. Cut the old cable on the side that is NOT the male USB plug (ex. the micro usb part should be cut off). Fish the cable through the base, leave a little slack~ 5 cm to be able to work and glue the hole so the cable does not move.7 Connect red wire of pins to the red wire on the usb cable by twisting together and do the same for black wires.8 Solder the twisted pairs and heatshrink them or use electrical tape, leaving enough to attach them to the female usb you glued earlier.9 Connect the USB cable wires with the cables for charging pins to the female usb port by soldering them and got glue over them! (Use a diagram on internet to check pinout - Female USB 2.0 pinout) (DOUBLE CHECK)10 Check magnets to see which side attracts to the mouse bottom and install them accordingly in the notches of razer1 part.11 Assemble everything and close the case.Congrats, you have a DIY charging usb 2.0 dock/station for your Razer Naga Pro Mouse :)