Raytheon Spinning Crank Knob Kit for Proton Pack (remix)

thingiverse

Thanks to mr_kiou, I was able to slice and dice this crank knob an build a kit to allow for a spinning crank knob. This prints in 3 parts: handle, body, and cap. This print is intended for resin printers. I dont think FDM has the tolerance for this application though I could be wrong. To assemble1- insert and glue a .63mm wire or rod into the handle.2- thread the rest of the rod through the coresponding hole in the body3- cut the wire to allow a bit of play but not too much as to be loose4- glue the small cap to the end of the rod/wire to cap it off.note: the rod or wire should not be visible outside the body. see images