Raynox 150/250 covers

thingiverse

This design isn't allowed to sell! The case supplied with the Raynox 250 magnification macro lens is laughably large, so I created this simple yet effective rear cover and front lens cap. Print without support. After printing, wiggle the tabs slightly and then place the cap with a tab facing towards a hard surface and push firmly until it snaps loose. Do the same for the other side. There's only a 0.3mm gap in the design so it might stick together somewhat. I've printed in 0.15mm PLA and PETG without issues. As always, if you find this useful, a tiny donation goes a long way to show appreciation. For more sizes of the same cap look here: https://www.thingiverse.com/thing:4418284 EDIT: Added an internal thread in the rear cover so the front cap can be stored when the lens is in use.