RavPower 32000mAh powerbank mount

thingiverse

I needed to be able to mount a RavPower 32000 mAh power bank battery to a music stand to power some equipment. The two parts of the box just snap together to hold the battery in place. The clamp parts fit a Gibraltar 6713 stand. I glued the clamp parts to the box body using Gloop 3D glue. The holes on the side of the box body for the switch and charge cable are not in quite the correct place. Really need to be a bit further towards the rear of the box but they work as they are so I did not change them. The clamp bolts are 1/4 inch with the heads ground down to a square to fit into the clamp and a wing nut on the other end. Once the clamp is glued to the body you cannot get the bolts out as the box body covers the heads but not a problem in my case. You can always teak it. Printed on an Ender 3 Pro. I found I needed to use glue on the (glass) bed to stop it warping. Printed with 1.75 PLA using supports, a bed temp of 65 and nozzle temp of 210.