Rav4-2011 Phone Holder

prusaprinters

The original was a simple and effective design, but I found the viewing angle to be better with the phone angled toward the driver at 22.5-degrees. This also increases volume knob accessibility. It causes the phone to lean left a bit though, so I also rotated the end 5-degrees clockwise. For the phone-holding frame, I narrowed it by 3mm to (hopefully) fit a Pixel3a with Fingic case (https://amazon.com/gp/product/B07RTJF958). Also removed material to reduce filament usage, increase flexibility, allow greater access to USB/AUX ports, and make room for a screw-head on the bottom hole of the back bracket. Perhaps most importantly, I added a little bulge on the right side of the frame, to allow for the power/volume buttons to fit. The bracket is unchanged from the original - included simply for ease-of-access. Category: Mobile Phone