Ratta Supernote Standard Pen Body

thingiverse

My Ratta Supernote pen was damaged and the outer body had to be replaced, while the core (the part that Ratta sells as refills) was still usable. I needed a part that would support the delicate core without damaging the copper coil near the tip. The core goes inserted inside the 'pen_body' part. Then the 'pen_cap' encloses the tip. Finally I use regular duct tape to secure the two pieces together, and to provide a surface with good grip. I actually prefer this feel to the original pen. This can be used to replace the outer body of a standard pen or to create custom Supernote pens using a refill. Note: this is not compatible with the standard pen end cap, which I didn't use anyway because it was too loose. Printed very well on a Prusa Mk3 with standard settings.