RatRig Vcore 3.1 EVA3 Orbiter 2.0 Duet Toolboard 1LC

thingiverse

I made a Duet 3D Toolboard 1LC holder to connect to the EVA3 system and add stability. I added an arm that screws directly into the Orbiter screw, just use a longer M3x30 screw to connect the orbiter to the board back. Apologies if this design is not very good, i made this quick and prototype only. I can make changes if requested and they are worthwhile. I used the smaller cable holder from another design which i added as remix, but no changes were made to that part. Print Settings Print in the orientation shown in the picture of this post. You will use a very small support just for the back piece. I printed in ABS. 0.2 mm layer height, supports yes - build plate only.