Rat Bait Station

prusaprinters

<p>I found I needed a rat bait station as the rats in the area are out of control.<br/> So I designed one in openscad.</p> <p>The model is pre cutup into printable sized chunks.</p> <p>Printing:<br/> I printed with a 0.4 nozzle and 0.35mm layers.<br/> The tee requires support.<br/> You need two of the body extensions and one of the rest.<br/> I used PLA, time will tell if the rats prefer the PLA to the bait.</p> <p>To use just hang bate on a stiff wire from the cap down the feeder tube. As each block is consumed a new one falls down the wire to replace it.</p> <p>The tolerance in the joiners is a little sloppy, needs glue. But good enough. Source is included, so if you want better, feel free to edit to.</p> <h3>Print instructions</h3><p>Category: Outdoor &amp; Garden</p>