Raspbian Macintosh Classic for Raspberry Pi 4B

thingiverse

*** Version 2 is out... check it out here: https://www.thingiverse.com/thing:5179724 *** This is the classic Raspbian design, designed around a 10.1" display. Version 1, definitely a work in progress! I plan on using a RPI 4B. It's printing now, so I don't know if things work, or go together. Everything was designed to be printed on a 300x300 print bed. I found the first error. The display is not centered in the screen, so I had to shift it over a bit. Also the mounting holes were too far outboard for me to use my drill motor on it. So I moved them inboard 20mm. I also turned the holes into slots. You can ignore the outboard slots, those are just so I can use the screen with my base. They will go away in the next version! I have not figured out the electronics yet, so the inside is just an empty box, and the back access plate doesn't have any cutouts in it yet. I will add a drawing of the access plate so you can model and add your own cutouts. The display I am using comes out of this: https://www.amazon.com/dp/B08FHF7H3L/ref=cm_sw_em_r_mt_dp_4TS06SE930711Z8H19AY?_encoding=UTF8&psc=1 The hardware is M4: https://www.amazon.com/dp/B08RDNNDHZ/ref=cm_sw_em_r_mt_dp_ZWVMARWX704XG18KHSP5?_encoding=UTF8&psc=1 There's approx 13 tapped holes. You could tap them with an M4 tap, or you could use some female thread knurled nuts. Your Raspbian Classic will last a lot longer with the knurled nuts: https://www.amazon.com/dp/B08GWKW1K7/ref=cm_sw_em_r_mt_dp_VR5RRT8J5HFDZ3NDFJWS?_encoding=UTF8&psc=1 Suggestions are welcomed! :-)