Raspberry Pi Zero Case with 1.8" OLED

thingiverse

This is another case being used as a desktop indicator. Designed to work with the Zero W, but connectors are brought to the edge so an older zero can be used if necessary. M3 bolts x8mm hold side panels in place. The panels are identical, but both ways up are shown in STL so that when printed, a good side can be used on the outside of the case. The pi is held in place with some 2.5mm nuts and bolts. OLED is an atypical ST7735r 1.8" SPI module. There are a few designs of these out there and this one has connectors at each end. Another case will be released shortly to handle the other type of OLED that has the connector at one end, as the mounting holes are spaced differently. The case is designed at 50mm wide so that a 50mm wide piece of wood veneer can be used if desired. Mounting bolts for the OLED are M3 x 12mm.