Raspberry Pi Zero 2 W Clipping Case for Prusa

prusaprinters

<p>This is <a href="https://www.prusaprinters.org/social/21719-marius">Marius</a>’ “<a href="https://www.prusaprinters.org/prints/84138-slim-raspberry-pi-zero-2-w-case">Slim Raspberry Pi Zero 2 W Case</a>” with a spacial backplate that can interlock on 3030 extrusion clips (themselves based on <a href="https://www.prusaprinters.org/social/32891-shaun-doe">Shaun Doe</a>’s “<a href="https://www.prusaprinters.org/prints/50309-prusa-mk3-mk3s-mk3s-lcd-cable-clip/files">Prusa MK3 / MK3S / MK3S+ LCD cable clip</a>“).</p><p>I’m using it to run a minimal Octoprint on a Raspberry Pi Zero 2 W. See images!</p><h5>&nbsp;</h5><h5>Includes:</h5><ul><li>Backplate (back) case with female interlocks (<code>01_backplate_interlock.stl</code>)</li><li>Twisting 3030 extrusion clips with cable passthrough:<ul><li>With male interlock for the backplate (<code>02_clip_wire_interlock.stl</code>)</li><li>Without any interlock, to hold cables (<code>03_clip_wire.stl</code>)</li></ul></li></ul><h5>&nbsp;</h5><h5>Not included:</h5><ul><li>Frontplate (top) of your choice from <a href="https://www.prusaprinters.org/prints/84138-slim-raspberry-pi-zero-2-w-case">Slim Raspberry Pi Zero 2 W Case</a></li><li>4x M2.5 screws (M2.5x8 should be fine)</li></ul><h5>&nbsp;</h5><h5>Print and assembly instructions</h5><ol><li>Print 1x backplate (<code>01_backplate_interlock.stl</code>)</li><li>Print 2x interlock clips (<code>02_clip_wire_interlock.stl</code>)</li><li>Print clips, as desired (<code>03_clip_wire.stl</code>)</li><li>Assemble the case (backplate, frontplate, 4x screws)</li><li>Attach the 2x interlock clips to the extrusion and snap-in the cables</li><li>Slide in the case over the interlock (adjust clips as needed)</li><li>Use extra clips to fasten cables along the extrusion<br>&nbsp;</li></ol>