Raspberry Pi with Touch Screen Enclouser (For Klipper)

thingiverse

Wanted something like the sonic pad with ho cables outside design is a little rough but functional, the 6 pin connector on the side was for the input shaper sensor but i ended up using a USB one ended up swapping it for a 4 pin connector or i2c so can be used to which ever you like, on the square power connector fits in snug but i recommend a bad of super glue and some hot glue to hold it well, i didn't work too much on the stand as to i am unsure how i want to post it but the m8nt for the stand makes any future designs or updates easier, Finally the fan can be optonal i used a 30mm x 10mm fan and it does make the pi or in my case the CM1 run about 5degrees cooler and has been running non stop for over a week as on now with no issues and stable temps