Raspberry Pi Stand (A+ B+ form factor)

prusaprinters

<p>This is a raspberry pi stand. Its inspired from the adafruit stand for the pi zero (<a href="https://learn.adafruit.com/raspberry-pi-zero-stand/">https://learn.adafruit.com/raspberry-pi-zero-stand/</a>) but with a few fundamental changes</p> <p>The hight where the pi is screwed in is quite high up. Mainly because when you put a hat on the pi zero stand it tended to tip over with the weight. This I hope should be better in this design.</p> <p>The screw holes are hat compatible so you can put a A+ or a pimoroni black hat hacker on it or just a Hat on its own. Of course you could put a regular pi on this stand but the USB would be sticking out to the side. (Not a big deal for me)</p> <p>The hole for the cable management is a little higher than the Zero version too because stiff cables tended to make the whole stand lift off the table. This time I hope the placement allows for cable bend.</p>