Raspberry Pi shield for Snapmaker 2 A350

thingiverse

# RASPBERRY PI SHIELD FOR SNAPMAKER 2.0 A350 This model allows you to position a Raspberry Pi in the front of your Snapmaker 2.0 A350. The shield slides between the two linear motion rails that move the printbed, and is kept attached to them via 4 M4x8 screws. It has front ventilation and the intake for a 30mm fan to keep the Raspberry Pi cooled. For this project you'll need: - n.4 M4 x 8 screws - n.4 M2 x 8 self tapping screws to fix the Raspberry Pi to the shield - n.4 M2 x 12 self tapping screws to fix the fan. (if your fan is thinner or thicker you might need longer or shorter screws. The one I used is 7 mm wide). I suggest to insert the part with the Raspberry Pi hanging upside down, to prevent any debris from falling into it when the bed slides towards the back of the printer. Make sure that any cable doesn't get stuck on the printbed, I suggest to make them go under the aluminum base.